Dimensions: 130cm * 70cm
Application Methods:
Dry Application:
1. Clean the area where you plan to apply the sticker thoroughly.
2. Peel off the backing paper and apply the sticker from the top down.
3. Use a plastic scraper wrapped in a towel to remove air bubbles.
Wet Application:
1. Clean the application area.
2. Spray a detergent solution on both the application area and the sticky side of the sticker.
3. Apply the sticker to the car and use a plastic scraper to push out air bubbles from the center outwards.
4. Let it dry naturally for 30 minutes, then remove the transfer membrane.
Precautions:
1. Avoid waxing the car for a week before applying the sticker and keep it dry for 24 hours after application.
2. Do not wash the car for 7 days after applying the sticker.
3. Do not apply the sticker on rainy days.
Note that there may be slight color differences between the screen and the actual sticker due to monitor settings.
These unique 3D ultraviolet - proof rear windshield car stickers come in dimensions of 130cm * 70cm. You can apply them using either the dry or wet method. For the dry method, first clean the spot, then peel and stick the sticker from top to bottom. Use a towel - wrapped plastic scraper to get rid of bubbles. For the wet method, clean the area, spray a detergent solution, stick the sticker, push out bubbles from the center, let it dry for 30 minutes and remove the transfer membrane. Before applying, don't wax the car for a week and keep it dry for 24 hours after. Don't wash the car for 7 days post - application and avoid applying on rainy days. Remember, there might be small color differences because of your monitor settings.
